Samson SM10 - SM10 Technical Specifications

SM10
14
Inputs
Microphone XLR balanced (2)
Line 1/4” TRS balanced (Ch 1-8),
1/4” stereo (Ch 9-10)
Input Impedance
Mic 1.5K Ohms
Line 23K Ohms (+4 dBu, Ch 1-8)
40K Ohms (-10 dBV, Ch 1-8)
20K Ohms (Ch 9-10)
Maximum Gain
Mic 65 dB
Line 39 dB
Line Operating Level +4 dBu / -10 dBV selectable
Maximum Input Level (1 kHz, ±3 dB)
Mic Input -4 dBu
Line Input +28 dBu
Equivalent Input Noise - 123 dBu unweighted
Outputs
Main Outputs
Type 1/4” TRS balanced (2), XLR (2)
Output Impedance 200 Ohms Main Out
Gain Range -∞ to +15 dB
Max output level +22 dBu
MON (Pre Fade Out) 1/4” impedance balanced mono output
(front panel), Stereo MON (rear panel)
EFX (Post Fade Out) 1/4” unbalanced
Output Impedance 100 Ohms
Headphone 1/4” TRS Stereo
Output (600 Ohm load) 100 mW
System
Frequency Response 10 Hz – 23 kHz ±1 dB
Signal-to-noise ratio > 90 dB typical
THD <0.01% typical
Crosstalk (1 kHz) -70 dB between input channels
-70 dB between input/output channels
Phantom Power 48 Volts DC
Power Requirements 120-240 VAC / 50-60 Hz
Dimensions 19” L x 8.25” W x 1.75” H
484mm L x 210mm W x 44.5mm H
Weight 6 lbs / 2.8 kg
Specications