DI19PS 3-1
3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
DI19PS monitor.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
3-1 Disassembly
Cautions : 1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
3. R/Cover opening jig : BH81-00001A
1. Place monitor face down on cushioned table.
Remove 1 screws from grip on the stand and
remove back cover from the stand.
2. Disconnect cable and remove 4 screws from
the stand.
3. Lift up the stand and insert the opening drive
into the grooves at each side and press until it
clicks.
4. Disconnect function cable and remove 12
screws from the shield.
5. Remove the cover front and remove 4 screws
from the panel.
To Next Page
Loading...
