¦ Setting Auto Initialize
When you clone settings from one TV to another, you clone both the guest side menu and hotel side menu settings: Picture,
Sound, Input, Channel, Setup, and Hotel Setup. This lets you set nearly all of the menu values on your hospitality TVs to
the same, standard settings. If you allow guests access to the guest side menus, for example the Picture menu, they can
change the settings in those menus so they are no longer standard. If you set the Setting Auto Initialize function to on the TV
automatically restores (initializes) any guest-side menu values to the cloned, standard values when the TV is turned off and
then turned on again. Note that Setting Auto Initialize works on cloned guest side menu values only. Settings which have not
been cloned are ignored.
The table below lists the settings that are restored to their cloned values when you set the Setting Auto Initialize function to
on.
Menu Menu Item Menu Menu Item
Picture Menu
Picture Mode
Sound Menu
Sound Mode
Backlight Sound Effect
Contrast DTS TruSurround
Brightness DTS TruDialog
Sharpness Equalizer
Color Speaker Settings
Tint (G/R) Speaker Select
Picture Size Auto Volume
Picture Size TV Installation Type
Position Reset Sound
PIP
System Menu
Menu Language
Advanced Settings Time
Dynamic Contrast Clock
Black Tone Sleep Timer
Flesh Tone Wake-up Timer
RGB Only Mode Eco Solution
Color Space Energy Saving
White Balance Eco Sensor (only for 40" and above models)
Gamma No Signal Power Off
Motion Lighting Auto Power Off
Picture Option Auto Protection Time
Color Tone Change PIN
Digital Clean View General
MPEG Noise Filter Game Mode
HDMI Black Level Boot Logo
Film Mode Anynet+ (HDMI-CEC)
Picture Off Anynet+ (HDMI-CEC)
Reset Picture
Auto Turn Off
DivX® Video On Demand
To Next Page
Loading...
