Samsung 740N - Folie 39

9. Panel & Model Define Process
9. Panel & Model Define Process
1.
1.
Control ‘Bright / Contrast’ to ‘Zero(0)’
Control ‘Bright / Contrast’ to ‘Zero(0)’
2.
2.
Push the ‘Enter’ key for 5 seconds
Push the ‘Enter’ key for 5 seconds
3.
3.
A nd then you can see ‘SV C OSD’.
A nd then you can see ‘SV C OSD’.
4.
4.
SV C OSD displays ‘Firmware check sum/Panel,Lamp Life time’
SV C OSD displays ‘Firmware check sum/Panel,Lamp Life time’


If you want to get out of SV C mode, just Soft Power Off.
If you want to get out of SV C mode, just Soft Power Off.
5.
5.
A fter checking Software version, you can choose the M ethod 1 or M ethod 2 of
A fter checking Software version, you can choose the M ethod 1 or M ethod 2 of
Panel & M odel D efine Process as below,
Panel & M odel D efine Process as below,
Before Software V ersion : xxxxx
Before Software V ersion : xxxxx


Use the M ethod 1
Use the M ethod 1
A fter Software V ersion : xxxxx
A fter Software V ersion : xxxxx


Use the M ethod 2
Use the M ethod 2
Check sum
Check sum
Software V ersion
Software V ersion