SVC Mode – Panel Change
SVC Mode – Panel Change
* * * If you change the PA NEL, you should change the information of PA NEL in SV C mode * * *
* * * If you change the PA NEL, you should change the information of PA NEL in SV C mode * * *
1. In SV C mode, choose ‘Panel’ item with ‘ ’ key.▲
1. In SV C mode, choose ‘Panel’ item with ‘ ’ key.▲
2. Push the ‘M ENU’key for 5 seconds. A nd then ‘Ch. No’ will counter up and Lamp time will be
2. Push the ‘M ENU’key for 5 seconds. A nd then ‘Ch. No’ will counter up and Lamp time will be
Zero(0)
Zero(0)
To Next Page
Loading...
