9.SVC Mode - Information
9.SVC Mode - Information
1.
1.
Control ‘Bright / Contrast’ to ‘Zero(0)’
Control ‘Bright / Contrast’ to ‘Zero(0)’
2.
2.
Push the ‘Enter’ key for 5 seconds
Push the ‘Enter’ key for 5 seconds
3.
3.
A nd then you can see ‘SV C OSD’.
A nd then you can see ‘SV C OSD’.
4.
4.
SV C OSD displays ‘Firmware check sum/Panel,Lamp Life time’
SV C OSD displays ‘Firmware check sum/Panel,Lamp Life time’
If you want to get out of SV C mode, just Soft Power Off.
If you want to get out of SV C mode, just Soft Power Off.
Panel Information
Panel Information
Check sum
Check sum
Soft ware V ersion
Soft ware V ersion
To Next Page
Loading...
