Samsung AC***KNLDCH - Adjusting air flow; Automatic Air-Volume Adjustment

36
Adjusting air ow
Connecting the connection cord
Terminal Block SPEC (Indoor)
AC POWER : M4 SCREW
8.4 9.5
COMMUNICATION : M4 SCREW
8.4
9.5
10
10
Tightening Torque
M4 _LHGrDN _MCGrGU
Automatic Air-Volume
"XBZ.%4
Main Menu
Sub-menu
123 546
SEG Used
1).Press the and buttons at the same time for more
than 3 seconds and then a Main menu will be displayed.
2).Press the
/ button to select and then press
button to enter a Sub-menu setting screen.
3).Press the
/ button to select and then press
button to enter a automatic air-volume setting screen.
4).Press the
/ button to select 1 to enable automatic
air-volume operation.
4FMFDUNPEF/PBOETFUUPiw
6). Press the
/ button to select 3 and then press
button to enter input voltage.
1SFTTUIF
/ CVUUPOUPTFMFDU_UPTFUWPMUBHF
(1 : 220V, 2 : 230V, 3 : 240V)
When DPM is installed, Automatic Air-Volume function cannot be performed simultaneously for all indoor units.
Automatic Air-Volume function must be performed for each indoor unit with the wired remote control attached.
With its BLDC motor, you can use smart adjust the indoor unit fan speed depending on the installation condition.
If the external static pressure is high so that the duct becomes longer or if the external static pressure is low so that the
duct becomes shorter, Using the Automatic Air-Volume function,the volume of exhaust air has been adjusted to the
rated volume flow rate automatically.
Performing the Automatic Air-Volume function.
- Check the air conditioning unit stop.
Press the Power button to stop the air conditioner
- Go to Service setting mode with remote controller.
( Only for AC777MNHDCH )
8). Press the button, then the air conditioning unit will start the fan operation for Automatic Air-Volume adjustment.
❈ Do not adjust the dampers during fan operation for Automatic Air-Volume adjustment.
9). Press
button to escape setting mode.
(During the automatic air-volume adjustment,[Main Menu] will be displayed
ttt
repetitively)
10). After 1 to 8 minutes, the air conditioning unit stops operating automatically when Automatic Air-Volume adjustment has
been carried out (fan operation icon will be o.)