Samsung AC***KNLDCH - Setting an indoor unit address and installation option; Indoor Unit Address and Option Settings

ENGLISH
41
Setting an indoor unit address and installation option
Set the indoor unit address and installation option with remote controller option. Set the each option
separately since you cannot set the ADDRESS setting and indoor unit installation setting option at the same
time. You need to set twice when setting indoor unit address and installation option.
Setting an indoor unit address
1) Press the and buttons at the same time for more than 3 seconds and then a Main menu will be
displayed.
2) Press the
/
button to select and then press button to enter a Sub-menu setting screen.
3) Press the
/ button to select and then press button to enter a Indoor Address setting screen.
1234 56
Data bit
4) Press the
/
button to set the Indoor unit Main/RMC Address.
5) Press the
button to save and complete the option setting.
6) Press the
button to exit to normal mode.
t Press the button anytime during setup to exit without setting.
t Address will not be applied if you don't press
button.
t Setting Main/RMC Address of an Indoor unit is available only with a master wired remote controller.
NOTE
t The Main/RMC Address which is currently setting will flicker.
t Data bit 1 and 2 present Indoor unit main address checking
t Data bit 3 and 4 present Indoor unit main address setting(outdoor unit reset is needed to set).
t Data bit 5 and 6 present Indoor unit RMC address setting/checking.
NOTE