12
Installation Procedure
English
Installation Procedure
Silence mode controller wiring diagram
R1
DRED port
(only Austrailia model)
R2
Outdoor unit
ASSY Control out
Non-voltage contact
R1,R2 are used for connecting solution product
(Centralized control systems, Interface modules etc.)
Connecting the outdoor-to-indoor power cable
and the communication cable
1-phase
LN
F1 F2
1(L) 2(N) L N
F1 F2
Outdoor-to-indoor
power cable
For connecting the power and
communication cables
Main power cable Communication cable
Cable tie
Indoor Unit
Outdoor Unit
NOTE
• Lay the electrical wiring so that the front cover does
not rise up when doing wiring work and attach the
front cover securely.
• Ground wire for the indoor unit and outdoor unit
connection cable must be clamped to a soft copper
tin-plated eyelet terminal with M4 screw hole(NOT
SUPPLIED WITH UNIT ACCESSORIES).
To Next Page
Loading...
