Samsung AC MXADKH Series - Page 11

11English
Installation Procedure
Type
Model Outdoor unit Input current (Amperes) Power supply
Indoor unit Outdoor unit
Rated Voltage range Outdoor unit
Indoor
unit
Total MCA MFA
Hz Volts Min
. Max . Cooling Heating
B
AC052MN4DKH/EU
AC052MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC052NN4DKH/EU
AC052MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC052MNNDKH/EU
AC052MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC052NNNDKH/EU
AC052MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC052MNMDKH/EU
AC052MXADKH/EU
50 220 to 240 198 264 20 20 2.5 22.5 22.5 25.0
AC052MNLDKH/EU
AC052MXADKH/EU
50 220 to 240 198 264 20 20 1.7 21.7 21.7 25.0
AC052MNCDKH/EU
AC052MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC052MNJDKH/EU
AC052MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC052MNADKH/EU
AC052MXADKH/EU
50 220 to 240 198 264 20 20 1.6 21.6 21.6 25.0
AC060MNNDKH/EU
AC060MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC060NNNDKH/EU
AC060MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC060MNMDKH/EU
AC060MXADKH/EU
50 220 to 240 198 264 20 20 2.5 22.5 22.5 25.0
C
AC071MN4DKH/EU
AC071MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC071NN4DKH/EU
AC071MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC071MN4PKH/EU
AC071MXADKH/EU
50 220 to 240 198 264 20 20 1.5 21.5 21.5 25.0
AC071MNNDKH/EU
AC071MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC071NNNDKH/EU
AC071MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC071MNMDKH/EU
AC071MXADKH/EU
50 220 to 240 198 264 20 20 2.5 22.5 22.5 25.0
AC071MNLDKH/EU
AC071MXADKH/EU
50 220 to 240 198 264 20 20 1.7 21.7 21.7 25.0
AC071MNCDKH/EU
AC071MXADKH/EU
50 220 to 240 198 264 20 20 1.0 21.0 21.0 25.0
AC071MNADKH/EU
AC071MXADKH/EU
50 220 to 240 198 264 20 20 1.6 21.6 21.6 25.0
AC071MNMSEH/EU
AC071MXASEH/EU
50 220 to 240 198 264 20 20 3.5 23.5 23.5 25.0
D
AC100MNMSEH/EU
AC100MXASEH/EU
50 220 to 240 198 264 22 22 3.5 25.5 25.5 28.0
NOTE
1 Voltage range
• Units are suitable for use on electrical systems
where voltage supplied to unit terminal is not
below or above listed range limits
2 Maximum allowable voltage variation between
phases is 2%.
3 Wire size & type must comply with the applicable
local and national code.
• Wire size: Based on the value of MCA.
• Wire type: 60245 IEC57(IEC) or H05RN-
F(CENELEC) grade or more.
4 MFA is used to select the circuit breaker and the
ground fault circuit interrupter (earth leakage circuit
breaker).
5 MCA represents maximum input current.
• MFA represents capacity which may accept MCA
• Abbreviations
MCA: Min. Circuit Amps. (A)
MFA: Max. Fuse Amps. (A)