25English
Installation Procedure
CAUTION
• SEG18 is applied in case of strong wind.
Option SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
Explanation PAGE
Individual control of a
remote controller
Heating setting
copensation
RESERVED RESERVED RESERVED
Indication
and Details
Indication Details Indication Details Indication Details
3
0 or 1 Indoor 1
0 Default
1 2°C
2 Indoor 2
2 5°C3 Indoor 3
4 Indoor 4
• If you input a number other than 0~4 on the individual control of the indoor unit(SEG 20), the indoor is set as
“Indoor 1”.
Example) If you want to set as “Exterior temperature sensor : USE, External control : USE, Number of hours using
filer : 2000hr”,
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 2 - 1 0 -
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 - - - - 0
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 - 0 - 0 6
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3 0 0 - - -
assign option codes except SEG 1, 7,13,19 which are page options.
* Level control: The centralized controller can limit the functions and inputs of connected products with this
function enabled. Example: Operation mode limit (Cooling only/Heating only/No limitation), Heating
temperature upper limit, Cooling temperature lower limit) To enable ‘Level control’ when applying the
DPM with the centralized controller, appoint the master (Set ‘Use of external control [SEG14] option to
4 or higher).
To Next Page
Loading...
