Samsung AC026JNNCEH - Page 23

Samsung Electronics 4-3
The procedure of setting option (cont.)
Option setting Status
12. Setting Cool mode
PressModebuttontobechangetoCoolmodeintheOFFstatus.
13.SettingSEG16,SEG17option
Press Low Fan button(
∨ ) to enter SEG16 value.
Press High Fan button(
∧ )toenterSEG17value.
Each time you press the button,
  …  will be selected in rotation.
14.SettingDrymode
PressModebuttontobechangetoDrymodeintheOFFstatus.
15.SettingSEG18,SEG20option
Press Low Fan button(
∨ )toenterSEG18value.
Press High Fan button(
∧ )toenterSEG20value.
Each time you press the button,
  …  will be selected in rotation.
16. Setting Fan mode
PressModebuttontobechangetoFanmodeintheOFFstatus.
17.SettingSEG21,SEG22option
Press Low Fan button(
∨ ) to enter SEG21 value.
Press High Fan button(
∧ ) to enter SEG22 value.
Each time you press the button,
  …  will be selected in rotation.
18.SettingHeatmode
PressModebuttontobechangetoHEATmodeintheOFFstatus.
19. Setting SEG23, SEG24 mode
Press Low Fan button(
∨ ) to enter SEG23 value.
Press High Fan button(
∧ ) to enter SEG24 value.
Each time you press the button,
  …  will be selected in rotation.
SEG16
SEG18
SEG21
SEG23
SEG17
SEG20
SEG22
SEG24
Step 4. Input option
Press operation button
with the direction of remote control for set.
For the correct option setting, you must input the option twice.
Step 5. Check operation
1. Reset the indoor unit by pressing the RESET button of indoor unit or outdoor unit.
2. Take the batteries out of the remote controller and insert them again and then press the operation button.
Step 3. Check the option you have set
After setting option, press
button to check whether the option code you input is correct or not.
Option [SEG2,3] [SEG4,5] [SEG6,8] [SEG9,10] [SEG11,12]
RemoteControllerDisplay
Option [SEG14,15] [SEG16,17] [SEG18,20] [SEG21,22] [SEG23,24]
RemoteControllerDisplay