Samsung AC026NNNDKH - Setting the Installation Options in a Batch

Samsung Electronics 4-7
• If any of SEG5 and SEG6 is set to a value in the range A to F, the main address of the indoor unit does not change.
• If SEG3 is set to 0, the indoor unit maintains the existing main address even if SEG6 is set to a new value.
• If SEG9 is set 0, the indoor unit maintains the existing RMC address even if SEG11 and SET12 are set to new values.
4-1-3 Setting the installation options in a batch
Option No. for an indoor unit address: 02XXXX-1XXXXX-2XXXXX-3XXXXX
1 Make sure that the power is supplied to the
indoor unit. If the indoor unit is not plugged in, it
must include a power supply.
F1
1(L)
2(M)
F2
V1
V2
F3
F4
Indoor Unit
2 Set the installation options of indoor units, by referring to the following table and by following the steps in Common
steps for setting the addresses and options on page 4-1.
• The installation options of indoor units are set to like a below table by default.
Model
AC026NNNDKH
AC035NNNDKH
AC052NNNDKH
AC060NNNDKH
AC071NNNDKH
Installation option
020000-100001-200000-
300000
020000-100031-200000-300000
• The SEG20 option, Individual control with remote control, allows you to control multiple indoor units individually
by using the remote control.
Option
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Function Page Mode
Whether
to dry the
Evaporator
Use of external
temperature
sensor
Use of central control
Compensation of
the fan RPM
Indication
and
details
Indication Details Indication Details
Reserved
Indication Details Indication Details Indication Details
0 2
0 Disuse 0 Disuse 0 Disuse
1 Use 1 Use 1
High
ceiling
mode
Option SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
Function Page
Use of drain
pump
Reserved Reserved
Compensation of the
wind-free fan RPM
Dew removal
operation in
Wind-Free mode
Indication
and
details
Indication Details Indication Details
Indication Details Indication Details
1
0
Disuse
Model
AC026NNNDKH,
AC035NNNDKH,
AC052NNNDKH,
AC060NNNDKH
AC071NNNDKH
0
Maintain
blade status
in Wind-
Free mode
0
Default
3 step ↑
1 Use
1
1 step ↑ 2 step ↑
2
Use with
3 minute
delay
2
2 step ↑ 1 step ↑
1
(Default)
Cooling
operation
by opening
the blade
3
3 step ↑
Default