Samsung AC035MN1DKH/EU - Setting an Indoor Unit Installation Option

4-6 Samsung Electronics
4-1-4 Setting an indoor unit installation option
(Suitable for the condition of each installation location)
1. Check whether pow er is supplied or not.
- When the indoor unit is not plugged in, there should be additional pow er supply in the indoor unit.
2. The panel(display ) should be connected to an indoor unit to receive option.
3.
Set the installation option according to the installation condition of an air conditioner.
- The default setting of an indoor unit installation option is 02000-100000-200000-300000.
- Individual control of a r emot e controller(SEG20) is the function that controls an
indoor unit individually when there is more
than one indoor unit.
4. Set the indoor unit option by wireless r emot e controller.
▶
Drain pump(SEG8) will be set to ‘USE + 3 minute delay’ even if the drain pump is set to 0.
▶
Number of hours using lter(SEG18) will be set to ‘1000 hour’ even if the SEG18 is set to except for 2 or 6.
▶
*GZPVJOQVUBOVNCFSPUIFSUIBO_PGUIFJOEJWJEVBMDPOUSPMPGUIFJOEPPSVOJU4&(UIFJOEPPSJTTFUBTiJOEPPSw
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 2 RESERVED
Exterior temperature
sensor
Central control RESERVED
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 Drain pump RESERVEDRESERVEDRESERVEDRESERVED
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2External control
External control
output
S-Plasma ion Buzzer
Number of hours
using lter
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
Individual control of
a r emote controller
RESERVEDRESERVEDRESERVEDRESERVED
Indoor Unit
1(L)
F2
F1
2(N)