31English
Installation Procedure
7 Setting outdoor unit option switch and address
manually
a Setting the option
• Press and hold K2 to enter the option setting.
(Only available when the operation is stopped)
– If you enter the option setting, display will
show the following.
– Seg 1 and Seg 2 will display the number for
selected option.
– Seg 3 and Seg 4 will display the number for
set value of the selected option.
• If you have selected desired option, you can
shortly press the K2 switch to adjust the value of
the Seg 3, Seg 4 and change the function for the
selected option.
Example)
• If you have selected desired option, you can
shortly press the K2 switch to adjust the value of
the Seg 3, Seg 4 and change the function for the
selected option.
Example)
• After selecting the function for options, press and
hold the K2 switch for 2 seconds. Edited value of
the option will be saved when entire segments
blinks and tracking mode begins.
Option
item
Input
unit
SEG1 SEG2 SEG3 SEG4 Function
Channel
address
Main 0 0
AU
Automatic
setting
(Factory
default)
00~15
Manual
setting
Snow
accumulation
prevention
control
Main 0 1
00
Disabled
(Factory
default)
0 1 Enabled
Step for
Silence
mode
Main 0 2
00
Disabled
(Factory
default)
0 1 Step1
0 2 Step2
0 3 Step3
Type of
Silence
mode
Main 0 3
00
Automatic
Silence
mode
(Factory
default)
01
Manual
Silence
mode
CAUTION
• Edited option will not be saved if you do not end the
option setting as explained in above instruction.
࢜
While you are setting the option, you may press and
hold the K1 button to reset the value to previous
setting.
࢜
If you want to restore the setting to factory default,
press and hold the K4 button while you are in the
option setting mode.
– If you press and hold the K4 button, setting will be
restored to factory default but it doesn't mean that
restored setting is saved. Press and hold the K2
button. When the segments shows that tracking
mode is in progress, setting will be saved.
To Next Page
Loading...
Need help?
General
