Samsung AE160RXYDEG - User Manual

Other manuals for Samsung AE160RXYDEG

Installation And Maintenance Manual27 pages

Installation Manual52 pages

Questions and Answers

R
rgomezSep 18, 2025
What to do if Memory(EEPROM) Read Write error occurs on wired remote controller of Samsung Heating System?
- B
  Brandy RoseSep 18, 2025
  If you encounter a Memory(EEPROM) Read Write error (Wired remote controller data error) on your Samsung Heating System, check the wired remote controller.
T
terrybradleyAug 25, 2025
What to do if a gas leak error is detected in Samsung Heating System?
- T
  tannerchristinaAug 25, 2025
  If your Samsung Heating System indicates a gas leak error, you should check the coolant charging status. Also, examine the indoor EVA sensor. Ensure the outdoor unit service valve is open and verify that the indoor/outdoor installation pipe and wiring are correctly installed.
D
dylansmithAug 25, 2025
How to fix [Inverter] total current error/ PFC over current error in Samsung Heating System?
- R
  Ricky VelasquezAug 26, 2025
  If your Samsung Heating System is showing an inverter total current error or PFC over current error, begin by checking the input power. Next, verify the coolant charging status. Finally, ensure that the outdoor fan is operating normally.
F
fboltonAug 26, 2025
How to troubleshoot outdoor fan 1 error on Samsung Heating System?
- R
  Raven PerryAug 26, 2025
  If your Samsung Heating System is showing an outdoor fan 1 error, you should check the input power connection status. Verify the connection status between the motor and outdoor unit PCB. Also, inspect the indoor/outdoor fuse.
M
Morgan ValenzuelaSep 19, 2025
What does Zone 1 water-out temperature sensor error mean on Samsung Heating System?
- R
  robert69Sep 22, 2025
  If your Samsung Heating System displays a Zone 1 water-out temperature sensor error, it indicates a short- or open-circuit error of the Zone 1 water-out temperature sensor.
N
Nicholas MendozaSep 23, 2025
How to troubleshoot thermostat wrong connection error on Samsung Heating System?
- N
  Nathan TuckerSep 23, 2025
  If your Samsung Heating System shows a thermostat wrong connection error, check the wiring of the Hydro Unit Thermostat and verify the cooling/heating signal for concurrent wiring issues.
J
Jessica GonzalesSep 9, 2025
What to do if IPM is overheated in Samsung Heating System?
- W
  Wendy McclureSep 9, 2025
  If the IPM is overheated in your Samsung Heating System, check the INVERTER PBA's temperature. Power off and cool down the INVERTER PBA, then restart the outdoor unit.
S
sariasSep 12, 2025
How to troubleshoot indoor temperature sensor (open/short error) -Zone1 on Samsung Heating System?
- R
  Richard GouldSep 12, 2025
  If your Samsung Heating System displays an indoor temperature sensor (open/short error) for Zone1, check the indoor unit room temperature sensor and the indoor unit PCB connector CNS043(White).
S
Sarah HinesSep 3, 2025
What to do when Samsung Heating System OUTDOOR UNIT is under protection due to overload?
- L
  Lee GriffithSep 3, 2025
  If the outdoor unit of your Samsung Heating System is under protection due to overload, check the cycle status. Also, check the compressor when it starts.
A
Angela HarrisSep 1, 2025
What to do for indoor unit address setting error in Samsung Heating System?
- E
  ewellsSep 1, 2025
  If you encounter an indoor unit address setting error on your Samsung Heating System, check the address setting of the indoor units.