Samsung AJ024MCS4CH - Page 41

Samsung Electronics 4-21
The procedure of setting option (cont.)
Option setting Status
12. Setting Cool mode
Press Mode button to be change to Cool mode in the OFF status.
4FUUJOH4&(4&(PQUJPO
Press Low Fan button(
∨ UPFOUFS4&(WBMVF
Press High Fan button(
∧ UPFOUFS4&(WBMVF
Each time you press the button,
󱈓 󱈓 ⋯ 󱈓 will be selected in rotation.
14. Setting Dry mode
Press Mode button to be change to Dry mode in the OFF status.
4FUUJOH4&(4&(PQUJPO
Press Low Fan button(
∨ UPFOUFS4&(WBMVF
Press High Fan button(
∧ UPFOUFS4&(WBMVF
Each time you press the button,
󱈓 󱈓 ⋯ 󱈓 will be selected in rotation.
16. Setting Fan mode
Press Mode button to be change to Fan mode in the OFF status.
4FUUJOH4&(4&(PQUJPO
Press Low Fan button(
∨ UPFOUFS4&(WBMVF
Press High Fan button(
∧ UPFOUFS4&(WBMVF
Each time you press the button,
󱈓 󱈓 ⋯ 󱈓 will be selected in rotation.
18. Setting Heat mode
Press Mode button to be change to HEAT mode in the OFF status.
4FUUJOH4&(4&(NPEF
Press Low Fan button(
∨ UPFOUFS4&(WBMVF
Press High Fan button(
∧ UPFOUFS4&(WBMVF
Each time you press the button,
󱈓 󱈓 ⋯ 󱈓 will be selected in rotation.
4&(
4&(
4&(
4&(
4&(
4&(
4&(
4&(
Step 4. Input option
Press operation button
with the direction of remote control for set.
For the correct option setting, you must input the option twice.
Step 5. Check operation
1. Reset the indoor unit by pressing the RESET button of indoor unit or outdoor unit.
2. Take the batteries out of the remote controller and insert them again and then press the operation button.
Step 3. Check the option you have set
After setting option, press
button to check whether the option code you input is correct or not.
Option <4&(> <4&(> <4&(> <4&(> <4&(>
Remote Controller Display
Option <4&(> <4&(> <4&(> <4&(> <4&(>
Remote Controller Display