To Next PageTo Next Page
Need help?Do you have a question about the Samsung AJ024MCS4CH and is the answer not in the manual?
General| Model | AJ024MCS4CH |
|---|---|
| Cooling Capacity | 24000 BTU/h |
| Refrigerant | R410A |
| Power Supply | 220-240V, 50Hz |
| Operating Temperature (Cooling) | 18°C to 43°C |
Guidelines for safe and proper installation of the air conditioner.
Requirements for electrical connection and circuit protection.
Safety precautions to follow while the air conditioner is in use.
Detailed technical specifications for wall-mounted indoor units.
Identifying and resolving system errors based on display codes.
Troubleshooting codes for AJ***JNADCH indoor units.
Troubleshooting codes for AJ***JNNDCH indoor units.
Troubleshooting codes for AJ***JNLDCH indoor units.
Troubleshooting codes related to the outdoor unit's operation.
Initial checks before diagnosing unit malfunctions.
Further initial checks for common issues.
Interpreting error codes indicated on unit LEDs for diagnosis.
Interpreting error codes indicated on unit LEDs for diagnosis.
Diagnosing and resolving operational errors of the air conditioner.
Diagnosing and resolving operational errors of the air conditioner.
Diagnosing issues based on observed symptoms.
Diagnosing and fixing indoor temperature sensor faults.
Troubleshooting errors related to the indoor unit's BLDC fan motor.
Resolving communication errors between indoor and outdoor units.
Diagnosing and rectifying EEPROM circuit failures.
Initial diagnostic steps when the outdoor unit does not power on.
Procedures for checking the outdoor unit's controller for faults.
Troubleshooting issues related to the outdoor unit's fan operation.
Diagnosing and resolving compressor startup, lock, or rotation errors.
Troubleshooting IPM over current errors in the system.
Procedures for checking temperature sensors on the outdoor unit.
Procedures for checking outdoor unit temperature sensors.
Guidelines for inspecting and handling Printed Circuit Boards.
Steps for connecting refrigerant pipes and purging air from the system.
Procedure for refilling refrigerant after installation or leak.
