Samsung AJ024MCS4CH - Page 43

Samsung Electronics 4-23
1. Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional power supply in the indoor unit.
2. The panel(display ) should be connected to an indoor unit to receive option.
3. Set the installation option according to the installation condition of an air conditioner.
- The default setting of an indoor unit installation option is “02000-100000-200000-300000”.
- Individual control of a remote controller(SEG20) is the function that controls an indoor unit individually when there is
more than one indoor unit.
- No need to assign SEG3, 6, 9, 10, 11, 16, 21, 22, 23, 24 which are non applicable. Even though those segments are set,
they will be ignored.
- If you set the applicable segments with numbers other than the indiciated, the initial setting will be maintained.
4. Set the indoor unit option by wireless remote controller.
4-3-1-4 Setting an indoor unit installation option (suitable for the condition of each installation location)
Option No. : 02XXXX-1XXXXX-2XXXXX-3XXXXX
Option
(Mini 4Way only)
Explanation MODE
Use of external
temperature sensor
Use of central
control
RPM setting
compensation
Indication
and
Details
Indication Details Indication Details Indication Details Indication Details
0. Not used
1. High ceiling mode
2. High ceiling kit
3. Low noise operation
mode
02
0 Disuse 0 Disuse
1Use1Use
Option
Explanation
Use of drain
pump
Master / Slave
Indication
and
Details
Indication Details Indication Details Indication Details
1
evals0esusiD0
retsam1esU1
2
Use +
3minute
delay
Option
Explanation
Use of external
control
Setting the output
of external control
S-Plasma ion Buzzer control
Number of hours
Indication
and
Details
Indication Details Indication Details Indication Details Indication Details Indication Details Indication Details
2
0 Disuse 0
Thermo
on
0 Disuse 0
Mixed operation
control 1/Use
buzzer
2 1000 Hour
1
ON/OFF
Control
1
Operation
on
1 Use
1
Mixed operation
control 1/Disuse
of buzzer
6
2000
Hour
2
OFF
Control
2
Mixed operation
control 2/Use
buzzer
3
WINDOR
ON/OFF
3
Mixed operation
control 2/Disuse
of buzzer