26
Refrigerant pipe installation
English
Installation Procedure
Examples of refrigerant pipe installation
H/P
1 Using Y-joint
2 Using distribution header
H/R
Using Y-joint
MCU
MCU
MCU
MCU
MCU
Note 1)
MCU
Note 1) Direct-connected indoor unit without MCU (for HR only)
– This indoor unit can only be used for cooling operation. (Heating operation is not possible.)
– Connect indoor unit to liquid and low pressure gas pipe.
– Change the installation option for direct-connected indoor unit without MCU. (refer to the indoor unit installation manual)
ki]_TXX\_XhTWWptk}tGzYGvhhluUGGGY] YWYYTWXTYWGGG㝘䟸G[a\_aX_
To Next Page
Loading...
