Need help?Do you have a question about the Samsung AM***MXWA Series and is the answer not in the manual?
General| Brand | Samsung |
|---|---|
| Model | AM***MXWA Series |
| Category | Air Conditioner |
| Language | English |
Hazards or unsafe practices resulting in severe injury or death.
Hazards or unsafe practices resulting in minor injury or property damage.
Critical installation warnings for safety and proper functionality.
Precautions for drainage, flare nut tightening, gloves, and unit placement.
Guidelines on pipe length, tools, and safety.
Important safety information for welding.
Table for selecting pipe sizes based on capacity and length.
Table for selecting pipe sizes between branch joints.
Table for selecting pipe sizes to indoor units.
Table for selecting pipe sizes based on capacity and length (H/R).
Table for selecting pipe sizes between branch joints.
Formula and steps for calculating refrigerant.
Specifications for pipe temper grade and minimum thickness.
Instructions and tools for pipe cutting and flaring.
Procedures for connecting flared pipes.
Connecting pipes to outdoor units for H/P and HR systems.
Safety precautions for welding pipes to outdoor units.
Instructions for connecting outdoor units using branch joints.
Guidelines for installing vertical traps.
Diagrams and classification of installation types.
Tables for pipe length limits and EEV kit.
Tables for maximum allowable pipe lengths in H/R systems.
Steps for selecting reducers and blocking unused ports.
Instructions for installing branch joints between outdoor units.
Tables for MCA and MFA values.
Warnings and precautions for electrical work.
Diagrams for 3-phase and single-phase power wiring.
Connecting power cables to terminal boards.
Importance and procedures for grounding.
Test using nitrogen gas.
Steps for vacuum drying pipes and indoor units.
Procedure for collecting refrigerant into a container.
Information on fluorinated greenhouse gases.
Explanation of DIP switches.
Explanation of setting outdoor installation options.
How to enter and set options using tact switches.
Key operation and display segments for K1.
Key operation and display segments for K2.
Key operation and display segments for K4.
How to set MCU addresses and ports.
Setting pipe addresses manually.
Auto pipe pairing operation.
Step-by-step guide to perform auto pipe pairing.
Precautions before trial operation.
To Next Page