Samsung AM DNCDKG Series - Page 44

44
English
Troubleshooting
Installation manual
Option setting Status
5 Set the SEG6 and SEG8 values:
a Set the SEG6 value by pressing the (Low Fan) button repeatedly until the
value you want to set appears on the remote control display.
b Set the SEG8 value by pressing the (High Fan) button repeatedly until the
value you want to set appears on the remote control display.
When you press the (Low Fan) or (High Fan) button, values appear in the
following order:
SEG6 SEG8
6 Press the (Mode) button. Fan and On appear on the remote control display.
7 Set the SEG9 and SEG10 values:
a Set the SEG9 value by pressing the (Low Fan) button repeatedly until the
value you want to set appears on the remote control display.
b Set the SEG10 value by pressing the (High Fan) button repeatedly until
the value you want to set appears on the remote control display.
When you press the (Low Fan) or (High Fan) button, values appear in the
following order:
SEG9 SEG10
8 Press the (Mode) button. Heat and On appear on the remote control display.
9 Set the SEG11 and SEG12 values:
a Set the SEG11 value by pressing the (Low Fan) button repeatedly until the
value you want to set appears on the remote control display.
b Set the SEG12 value by pressing the (High Fan) button repeatedly until the
value you want to set appears on the remote control display.
When you press the (Low Fan) or (High Fan) button, values appear in the
following order:
SEG11 SEG12
10 Press the (Mode) button. Auto and Off appear on the remote control display.
11 Set the SEG14 and SEG15 values:
a Set the SEG14 value by pressing the (Low Fan) button repeatedly until the
value you want to set appears on the remote control display.
b Set the SEG15 value by pressing the (High Fan) button repeatedly until the
value you want to set appears on the remote control display.
When you press the (Low Fan) or (High Fan) button, values appear in the
following order:
SEG14 SEG15
Setting an indoor unit address and installation option