91
ENGLISH
Electrical wiring work
• Are the power cable and communication cable tightened rmly on the
terminal board within the range of rated tightening torque?
• Have you checked for cross-connection of the power and communication
cables?
• Have you performed the earthing work 3 to the outdoor unit?
• Did you make sure to use 2-core cable (not multi-core cable) for the
communication cable?
• Is the length of the wire within allowed range?
• Is the wiring route correct?
Setting address
• Did you set the address of the indoor and outdoor units properly?
• Did you set the address of the indoor and outdoor units properly? (When
using multiple remote controllers)
Option
• If there is a possibility of the outdoor unit from vibrating, check whether the
anti-vibration frame is correctly installed.
To Next Page