Disassembly and Reassembly
120 Samsung Electronics
No Parts Procedure Remark
6) Disassemble the bolts that are assembled with
the indoor unit at the 4 panel corners.
7) Press the Steel Hangers at both sides of the
panel inwards, and rotate them 90 degrees to
remove it from the indoor unit’s Hock. Remove
the panel from the indoor unit.
2 Control-Box
1) Disconnect the Connector Wire that is con-
nected to the indoor unit’s PBA from the PBA.
2) Unscrew the 2 fixed screws on both sides of the
Control Box, and disassemble the Control Box
from the indoor unit. (Use +Screw Driver)
To Next Page
Loading...
