Disassembly and Reassembly
Samsung Electronics 3-89
No Parts Procedure Remark
4
ASS’Y FRONT PANEL
&
DISPLAY PCB PART
1) Remove the 4 screws from the bottom of
FRONT PANEL. (Use +Screw Driver)
2) Lift up the FRONT PANEL and separate it.
3) Separate the wire from the holder wire
and place the FRONT PANEL in the flat
floor.
4) Separate the wire from the holder wire of
FRONT PANEL rear.
5) Remove the 4 screws from the DISPLAY
COVER. (Use +Screw Driver)
6) Remove the 1 screw which is fixed to
DISPLAY PCB. (Use +Screw Driver)
Lift up
Holder wire
Holder wire
To Next Page
Loading...
