Operating Instructions and Installation
Samsung Electronics 3-13
No Parts Procedure Remark
3 Fan
&
Motor
1) Release the refrigerant at first.
2) Loosen fixing screw(CW). (Use Monkey
Spanner.)
3) Disassemble the pipes in both inlet and outlet
with welding torch.
4) Detach the Heat Exchanger.
4 Heat Exchanger 1)
Loosen 2 fixing screws(CCW) on both sides.
(Use +Screw Driver.)
2) Disassemble the pipes in both inlet and outlet
with welding torch.
3) Detach the Heat Exchanger.
Before you disassemble the pipes and
Condenser, be sure that there should be no
refrigerant remained in the unit.
5 Ass’y Valve 4-Way
&
Ass’y Valve EEV
1) Loosen 4 bolts(CCW) fixed to assemble Valve
Service with Bracket Valve like the picture on
the right side. (Use Monkey Spanner.)
2) Disassemble the pipes assembl
ed the suction
and discharge sides of the Compressor with
welding torch.
6 Compressor 1) Loosen the Nut(CCW) of Terminal Cover. (Use
Monkey Spanner.)
2) Detach the Terminal Cover and detach the
Connect Comp Wire from Compressor.
3) Disassemble the Fel
t Comp Sound.
4) Loosen the 3 bolts(CCW) at the bottom of
Compressor like the picture on the right side.
(Use Monkey Spanner.)
To Next Page
Loading...
