4-2 Samsung Electronics
Feature Display
Push the button to set the display panel to .
Every time you push the
button, the display panel reads ° ° °
°
......
° ° ° ° ° ° ° repeatedly.
Push the
button to
Fan
.
Push the
button to set the display panel to .
Every time you push the
button, the display panel reads ° ° °
°
......
° ° ° ° ° ° ° repeatedly.
Push the
button to set the display panel to .
Every time you push the
button, the display panel reads ° ° °
°
......
° ° ° ° ° ° ° repeatedly.
Push the
button to
Heat
.
Push the
button to set the display panel to .
Every time you push the
button, the display panel reads ° ° °
°
......
° ° ° ° ° ° ° repeatedly.
Push the
button to set the display panel to .
Every time you push the
button, the display panel reads ° ° °
°
......
° ° ° ° ° ° ° repeatedly.
7
8
9
10
11
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode
Selection key to set the display part and check the display part.
° The display part shows like below when each time you press Mode button .
Step 4: Pressing theON/OFF button (
)
When pressing the operation ON/OFF key with the direction of remote control for unit, the sound ’’Ding’’ or ’’Diriring’’
is heard and the OPERATION ICON( ) lamp of the display is flickering at the same time, then the input of option is completed.
(If the diriring sound isn’t heard, try again pressing the ON/OFF button.)
Step 5: Unit operation test-run
First, Remove the battery from the remote control.
Second, Re-insert the battery into the remote control.
Third, Press ON/OFF key with the direction of remote control for set.
•Error Mode
1
st
If all lamps of indoor unit are flickering, Plug out, plug in power plug again and press ON/OFF key to retry.
2
nd
If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the
correct option code is set up for its model.
4-1 Setting Option Setup Method(continue)
Auto
Cool
Dry
Fan
To Next Page
Loading...
