10
English
Installation
If using a multi system, refer to the manual
supplied with the outdoor unit .
Optional accessories
Insulated assembly pipe,
Ø 6.35 mm (1)
Insulated assembly pipe,
Ø 9.52 mm (1)
**09*******
**12*******
Insulated assembly pipe,
Ø 12.70 mm (1)
**18*******
Insulated assembly pipe,
Ø 15.88 mm (1)
**24*******
Pipe clamp B (3) Pipe clamp A (3)
Drain Hose, 2 m long (1) Foam Insulation (1)
Vinyl tape (2) PE T3 foam tube insulation (1)
Putty 100 g (1) Drain plug (1)
M4 x 25 tapped screw (6) Cement nail (6)
3-wire Power Cable (1) 3-wire Assembly Cable (1)
2-wire Assembly Cable (1)
Accessories in the outdoor unit package
Rubber leg (4)
NOTE
• A flare nut is attached to the end of each pipe
of an evaporator or a service port. Use flare nuts
when connecting the pipes.
• Wire assembly cables are optional. If they are not
supplied, use standard cables.
• The drain plug and the rubber legs are included
only when the air conditioner is supplied without
assembly pipes.
• If these accessories are supplied, they are in the
accessory package or outdoor unit package.
Tools
General tools
• Vacuum pump
(Backward flowing prevention)
• Manifold gauge
• Stud finder
• Torque wrench
• Pipe cutter
• Reamer
• Pipe bender
• Spirit level
• Screwdriver
• Spanner
• Drill
• L-wrench
• Measuring tape
Tools for test operation
• Thermometer
• Resistance meter
• Electroscope
To Next Page
Loading...
