13
English
Installation
Materials supplied by the installer
Make sure you have all other materials required for the
selected installation method and location.
IMPORTANT
• No mounting hardware, tubing, cables, and other
materials listed below are included with the appliance.
The required materials will vary, but may include the following:
• 1.8 m electrical whip for connecting the power from the
installed disconnect switch to the outdoor unit
• UV-resistant vinyl line set tape for the exposed line set
• Lines-set cover and fittings, if used
• Miscellaneous pipe hangers
• Miscellaneous screws and anchors for hanging pipe
hangers, the line-set cover, the indoor unit mounting
bracket, and so on.
• Electrical ring connectors for connecting all power and
communication wiring
• Electrical tape
• Refrigerant R-32 if additional refrigerant is required
due to line-set length
• Closed cell foam tape insulation (roll)
• Outdoor unit risers or L-brackets for wall installation
• Silicone caulking for sealing the wall penetration
• Rags
Tools
Make sure you have the required tools available.
General tools
• Vacuum pump
(Backward flowing prevention)
• Manifold gauge
• Stud finder
• Torque wrench
• Pipe cutter
• Reamer
• Pipe bender
• Spirit level
• Screwdriver
• Spanner
• Drill
• L-wrench
• Measuring tape
Tools for test operation
• Thermometer
• Resistance meter
• Electroscope
To Next Page
Loading...
