Samsung AR18HCF Series - Using the Auto Clean Function; Setting the Beep Sound

English-23
SETTING05
Using the Auto Clean function
Auto clean function will minimise the moisture inside of the indoor unit. Activate this function to help provide you with
clean air.
When the air conditioner is operating;
Indoor unit display
1. Press the Settings button.
2. Press the
, or Settings button until (Clean) indicator starts to blink.
3. Press the SET button to set the Auto clean function.
- 3 seconds after setting Auto clean function, (Clean) indicator on the remote
controller display will disappear and Timer indicator (
) will turn on the indoor
unit display. Auto clean function will be activated after the air conditioner stops
operating.
- Duration of the Auto clean function can be dierent depending on the previous
operation mode used.
Auto(cool),Cool,Drymode:30minutes.
Auto(heat),Heat,Fanmode:15minutes.
Cancel
 Press the Settings button  Press the , or Settings button to
make the (Clean) indicator blink and press the SET button.
• When the operation mode is set during Auto clean function is activated,
the air conditioner will operate in chosen operation mode and the Auto
clean function will be re-activated when the operation stops.
• During the auto clean function, indoor fan will continue to run and air
ow blade will remain open to expel ambient air.
•
lighting in Auto clean mode.
Setting the Beep sound
Beep sound from the indoor unit can be muted.
1. Press the Settings button.
2. Press the
, or Settings button until (Beep) indicator starts to blink.
3. Press the SET button to mute the beep sound.
- 3 seconds after setting Beep sound function, (Beep) indicator on the remote
controller display will disappear and Beep sound function will begin.
SG_GOOD_A3050_IB&IM_EN_DB68-05200A-03.indd 23 2/2/2016 8:26:09 AM