Samsung AS09HPB - Setting Option Setup Method

3-3Samsung Electronics
3-3 Setting Option Setup Method
ex) Option No. :
Step 1 : Enter the Option Setup mode.
1
st
Take out the batteries of remote control.
2
nd
Press the temperature button simultaneously and
insert the battery again.
3
rd
Make sure the remocon display shown as .
Step 2 : Enter the Option Setup mode and select your option according to the following procedure.
3 2
1
4
5 6
1
2
The default value is .
Otherwise, push the button to .
Every time you push the button, the display panel reads or
repeatedly.
✳ Setting is not required if you must
a value which has a default.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
3
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
4
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
5
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
6
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
24437A(1)_1 1/16/05 9:57 PM Page 3-3