3-10 Samsung Electronics
No Parts Procedure Remark
2 Fan
&
Motor
1) Remove the Nut Flange.
(Turn to the clockwise)
2) Separate the Fan.
3) Loosen 4 fixing screws to separate the
Motor.
4) Loosen 2 fixing screws and separate the
Motor Bracket from the Base.
3 Heat Exchanger 1) Loosen 2 fixing screws of left and right side.
2) Disassemble the inlet and outlet pipe by
welding.
3) Separate the Heat Exchanger.
Before you disassemble the pipes and
Condenser, be sure that there should be
no refrigerant remained in the unit.
4 Compressor 1) Open the Terminal Cover of Compressor and
unscrew the Connection Terminal.
2) Disassemble the inlet and outlet pipe of
Compressor by welding.
3) Loosen 3 bolts of the lower part.
4) Separate the Compressor.
Operating Instructions and Installation
To Next Page
Loading...
