Samsung CE1041DSB3 - Setting the time

12 English
Oven use
Oven use
Setting the time
Your microwave oven has an inbuilt clock. When power is supplied, “88:88” and
then “12:00” is automatically displayed on the display.
Please set the current time. The time can be displayed in either the 24-hour or 12-
hour notation. You must set the clock:
• When you rst install your microwave oven
• After a power failure
NOTE
Do not forget to reset the clock when you switch to and from summer and winter
time.
1. Press the Clock button.
2. Press the Up or Down button to set
time display type (12H or 24H). At that
time, press the Select button to set the
display type.
3. Press the Up or Down button to set the
hour.
4. Press the Select button.
Checking that your oven is operating correctly
The following simple procedure enables you to check that your oven is
working correctly at all times. If you are in doubt, refer to the section entitled
“Troubleshooting” on the page 65-68.
NOTE
The oven must be plugged into an appropriate wall socket. The turntable must be
in position in the oven. If a power level other than the maximum (100 % - 900 W)
is used, the water takes longer to boil.
Open the oven door.
Place a glass of water on the turntable. Close the door.
Operate the Microwave mode and set the time
to 4 or 5 minutes by pressing the Up and Down
button the appropriate number of times.
Result: The oven heats the water for 4 or
5minutes. The water should then be
boiling.
CE1041DSB3_TL_DE68-04429B-00_EN_Revise.indd 12CE1041DSB3_TL_DE68-04429B-00_EN_Revise.indd 12 3/9/2022 10:16:44 AM3/9/2022 10:16:44 AM