Alignment & Troubleshooting
Service Manual
4-66
Samsung Electronics
3) Light Image
1. Develop roller is
stained when the toner of developer
cartridge is almost
consumed.
Replace the developer cartridge and try to
print out.
Clean up the contaminated area by the toner.
Replace the HVPS if the problems are not
solved by the above four directions.
2. Ambient temperature
is below than 10¡C.
Wait 30 minutes after printer is powered on
before you start printing.
3. Bad contact caused
by the toner stains between the
high voltage terminal in the HVPS
and the one in the set.
4. Abnormal output from the HVPS.
Description
The printed image is light, with no ghost.
To Next Page
Loading...
