Copying_ 52
Basic copy
This is the normal and usual procedure for copying your originals.
1. Press Copy from the display screen.
2. Place the originals face up in the DADF or place a single original face
down on the scanner glass and close the DADF (see
"Loading originals"
on page 35).
3. Adjust the settings for each copy such as Paper Supply,
Reduce/Enlarge, Duplex and more in the Basic tab (see
"Changing the
settings for each copy" on page 54).
4. Set the copy features in the Advanced or Image tabs, if necessary (see
"Using special copy features" on page 61).
5. Enter the number of copies using the numeric keypad on the control
panel, if necessary.
6. Press Start from the control panel to begin copying.
• To cancel the current copy job, press Stop on the control panel.
To Next Page
Loading...
