EN
7
What to Do if You are in Doubt or Have a Problem
Before you call a service engineer your oven, check this list of possible
problems and solutions.
Neither the oven’s display nor the oven operate.
• Properly insert the plug into a grounded outlet.
• If the outlet is controlled by a wall switch, make sure the wall switch is
turned on.
• Remove the plug from the outlet, wait ten seconds, then plug it in again.
• Reset the circuit breaker or replace any blown fuse.
• Plug another appliance into the outlet; if the other appliance doesn’t work,
have a qualified electrician repair the outlet.
• Plug the oven into a different outlet.
The oven’s display works, but the power doesn’t come on.
• Make sure the door is closed securely.
• Check to see if packing material or other material is stuck to the door seal.
• Check for door damage.
• Press Cancel twice and re-enter all cooking instructions.
The power goes off before the set time has elapsed.
• If there has not been a power outage, remove the plug from the outlet,
wait ten seconds, then plug it in again. Reset the cooking instructions.
• Reset the circuit breaker or replace any blown fuse.
You see sparks or arcing.
• Remove any metallic utensils, cookware, or metal ties. If using foil, use
only narrow strips and allow at least one inch between the foil and interior
oven walls.
Using your microwave causes TV or radio interference.
• This is similar to the interference caused by other small appliances, such
as hair dryers. Move your microwave further away from other appliances,
like your TV or radio.
Door opening starts automatic operation of FAN
• When placing or removing food items, as soon as the Door is opened the
Lamp and Fan will start automatically. The automatic starting of the Fan is
intentional, so no service call is required. The fan will automatically stop
upon closing the door.
Setting Cooking Times & Power Levels
One-Stage Cooking
You can stop cooking at any time to check the food.
The maxium allowable cooking time is 30 min. If the time exceed 30
min, the display will show “E3”, then press Stop/Cancel() button
and repeat the steps.
1. Press the Power Level( ) button to select power.
By pressing the Power Level( ) button repeatedly, you
can select the power level - HI, MED, or LO.
2. Use the Number buttons to enter the cooking time. You
can set a time from one second to 30 minutes.
To set a time over one minute, enter the second as well.
• For example, to set 10 minutes, enter 1, 0, 0, 0.
3. Press Start( +30s) button to begin cooking.
Power Level Percentage Output
HI 100 % 1100 W
MED 70 % 770 W
LO 50 % 550 W
DEFROST 30 % 330 W
jtXW]`l|TWZZXWhluUGGwG^GGtSGzGXXSGYWW]GGXYa\[Gwt
To Next Page
Loading...
