Samsung D148W - Detergent and Softener Settings; Traditional Detergent Usage

10
EN
5/ DETERGENT PRODUCTS AND ADJUSTING THE WATER SOFTENER
Important:
It is very important to set the water softener correctly.
- If the setting is too low, there is the risk of chalky marks appearing.
- if the setting is too high, there is the risk of causing clouding of the glasses.
If you relocate, adjust the water softener setting as required.
• Traditional tablets
Non-multipurpose tablets should be placed in the external compartment (Fig 04) or, for optimum
performance, pull out the dispenser drawer and lay the tablet inside (Fig 05).
• Powders or liquids (Fig 03)
Fill at least up to the minimum mark for slightly dirty crockery and to the maximum mark for dirty
crockery. If the crockery is very dirty and for programmes with a pre-wash we recommend that you
add 5g of detergent (a dessert spoonful) into your dishwasher’s tub in accordance with the pro-
grammes table.
Important:
Keep these products out of children’s reach and away from dampness.
Only use products specially designed for dishwashers.
Fig. 04 Fig. 05Fig. 03
• FOR TRADITIONAL PRODUCTS
• Your machine must be specially adjusted to use traditional products.
TTeessttiinngg ssttrriipp
HHaarrddnneessss
0-10°F 10-18°F 18-25°F
25-40°F
40-55°F 55-70°F > 70°F
TTrraaddiittiioonnaall
pprroodduucctt
HIH0 H2 H3 H4 H5 H6
• Proceed as follows to set the softener on the control panel:
— Turn the selector to the “Set” position; the screen displays
SSEELL
to inform you that you are in setting mode.
— Press the
""DDeellaayyeedd ssttaarrtt””
button; the screen gives you the
setting (
HH44
factory setting).
— To change this setting (depending on hardness of water),
press successively on the "Delayed start" button. Each press
changes the setting. Refer to the table below.
— The setting is automatically confirmed when exiting Set; selector at programme or Stop position.