4-7
Samsung Electronics
4-7
Installation
Adjust the address of digital switch of indoor unit PCB in “B” chamber to “1”. In such a way, adjust the
address of digital switch up to chamber “F”.
• Put on the set power installed in each chamber.
2. Setting of wired remote controller
• Put off the set power where the wired remote controller is installed.
• Put on the option switch SW(DS01)2 of wired remote controller.
• Put on the set power where the wired remote controller is installed.
Caution :
• During the connection, connect the “R1” of indoor unit terminal board installed in each chamber with “R1”.
• During the connection, connect the “R3” of indoor unit terminal board installed in each chamber with “R3”.
• Do not connect the terminal R2 of indoor unit terminal board from “B” to “F” chamber except A” chamber.
• The option item, centralized controller shall be removed since the simultaneous use with wired remote controller is disable
during the group control.
• Adjust the address of indoor unit digital switch installed in each chamber so that it might not be duplicated.
Caution :
• The option can be applied when the power is put again after resetting the option of wired remote controller. Be sure to keep the
set power on/off after option setting.
Duct-ADH1800E-2-1 4/12/00 5:44 PM Page 4-7
To Next Page
Loading...
