ŝ23Ş
ASR button +/- button
ƈ You can use the +/- button to adjust the values for the RGB, ISO, white balance,
exposure compensation and Long Time shutter speed.
ƈ When the ASR mode is selected, ISO value is fixed as AUTO and Exposure value is
fixed as 0.0EV.
ſ If the menu is not selected in the Special Effect (Colour) menu, you can’t
select the RGB menu.
Main menu Sub menu
Available camera mode
RGB R (Red), G (Green), B (Blue)
ISO AUTO, 50, 100, 200, 400
Exposure compensation
-2.0 ~ 0.0 ~ +2.0 (0.5EV steps)
LT
Shutter speed/ Aperture Value
(Changed by zoom rate)
WHITE BALANCE
AUTO, DAYLIGHT, CLOUDY, FLUORESCENT H,
FLUORESCENT L, TUNGSTEN, CUSTOM.
ƈ RGB : Allows the user to adjust the R (Red), G (Green), and B (Blue) values of
the images to be captured.
ƃ Setting RGB Values
1. Press the +/- button, and then use the UP and DOWN
buttons to select the RGB icon ( ).
2. Use the UP/ DOWN/ LEFT and RIGHT buttons to
select the desired RGB value.
3. When you press the +/- button again, the value you
set will be saved and RGB setup mode will end.
ƈ Pressing this button will select the ASR (Advanced Shake Reduction) mode.
ƃ Things to watch out for using the ASR mode
1. The digital zoom will not operate in the ASR mode.
2. If the lighting conditions are brighter than fluorescent
lighting condition, the ASR doesn’t activate.
3. If the lighting condition is darker than in fluorescent
lighting condition, camera shake warning indicator
( ) will display. For best results only take pictures
in situations where the camera shake warning
indicator is not displayed.
4. If the subject is moving the final image captured may
be blurred.
5. Avoid moving the camera while the [Capturing!]
message is displayed to achieve a better result.
6. As the ASR uses the camera’s digital processor,
images taken using the ASR may take a little longer
for the camera to process.
Capturing!
To Next Page
Loading...
Need help?
General
