ŝ61Ş
Starting the MP3/ PMP mode
ƃ Changing the mode : If the [Full] menu was selected
1. Press the button located on the back of the camera.
2. Select a desired mode by pressing the Left/ Right button.
ƃ The automatic power off function will not operate if the a file is playing back.
ƃ Press the M (Mode) button or shutter button and the camera working mode
will be changed.
ƃ If there over 100 files in the memory, it takes a little longer for the camera to
process to the MP3/ PMP mode.
ƃ If there is no operation during the specified time (About 30 sec.) the LCD
monitor is turned off automatically and the camera status lamp blinks.
To use the camera, press any of the camera buttons except the Power
button.
ƃ Playing back the VBR (Variable Bit Rate) file A VBR file varies the amount
of output data in each time segment based on the complexity of the input
the data in that segment.When the VBR encoded files are played back, the
LCD will display as shown.
- The VBR icon will display instead of the Bit rate icon.
- The time line isn't displayed.
- Playing time will display but the whole running time doesn't display.
ƃ In the PMP mode, any camera buttons except for the Power button will not
be operated for 2 seconds of beginning and end of the multimedia file.
INFORMATION
3. Steps 3 is the same as steps 2~3 of Changing the mode in the
[Still/ Movie/ PMP] menu.
Confirm : Mode/ OK
MP3
Confirm : Mode/ OK
PMP
To Next Page
Loading...
Need help?
General
