Samsung DIGIMAX L60 - Starting the Recording Mode; Using Auto Mode

ŝ13Ş
Changing the recording mode Starting the recording mode
ƃ Changing the recording mode : If the [FULL] menu was selected
Steps from 1-4 are the same as those for selecting the [MODE] menu.
5. The recording mode used just before will display.
6. Press the M (Mode) button located on the back of the camera and the mode
selection menu will display.
7. To select the Auto, Program, Movie clip or Scene modes, press the Left /
Right button.
To move between the Auto, Manual, Movie clip menu line and Scene menu
line, press the Up / Down button.
8. Press the M (Mode) button and the mode selection menu will disappear.
[Pressing the Up button]
Portrait
[Pressing the Left button]
[Mode selection menu]
AUTO
MOVIE
[Selecting the Movie clip mode]
[Selecting the Scene mode]
Confirm:Mode/OK
Confirm:Mode/OK
Confirm:Mode/OK
ƈ How to use the Auto mode
Use this for shooting basic still images.
1. Select the [FULL] sub menu on the [MODE] menu (p.12).
2. Select the Auto mode by pressing the M (Mode)
button (p.13).
3. Point the camera towards the subject and
compose the image by using the LCD monitor.
4. Press the shutter button to capture an image.
[AUTO mode]
ƃIf the auto focus frame turns to red when you press the shutter button down
half way, it means that the camera cannot focus on the subject. Should this
be the case, the camera is less likely to capture an image clearly.
ƃAvoid obstructing the lens or the flash when you capture an image.
INFORMATION