Samsung Digimax S500 - Adjustment

45
Ⅳ.ADJUSTMENT
3. Adjustment
To adjust all items, all kinds of code by items have to be inserted in program file and saved them to the SD card
as TXT file type. The codes are listed below.
< Description of TXT file >
If the program is saved as shown above, the file name has to be saved as STS253ADJ.TXT
(for S500)/STS263ADJTXT(for S600).
※ SD CARD SHOULD BE FORMATTED BEFORE USING.
※ After inserting each code, [;] mark has to be inserted.
Codes of program Codes of program
<1> PROCESS CODE ; Insert the PROCESS CODE that you want to adjust
<2> 65535 ; 65535 --> DEFAULT
<3> PROCESS CODE ; Insert the PROCESS CODE that you want to adjust
<4> 0 OR 1 ; Insert 1 to write adjusted code to the EEPROM
<5> 0 OR 1 ; To save the result data to the SD card, insert 1 or 0
<6> CONDITION ; Insert each adjustment item's condition (See each adjustment item)
<7> SPEC ; Insert each adjustment item's value (See each adjustment item)
<8> NOT Not used
<9> NOT Not used
<10> NOT Not used
<11> NOT Not used
<12> NOT Not used
<13> NOT Not used
<14> 0 0 --> DEFAULT
<15> 0 0 --> DEFAULT