93
Ⅶ.TROUBLESHOOTING
④ How to upgrade the FULL VERSION FIRMWARE
Connect the camera with power supply and turn on the power. If the electricity current consumes
between 200 and 330mA and the camera doesn°Øt turn on, recover the flash memory by following
instruction.
1. Short the pattern on the Main PCB.
2. Download the Full version Firmware into the SD card.
3. Connect the power supply to the camera and turn on the camera.
4. The LED on the Main PCB will blink while the firmware is upgrading and the LED will be off after completing the
upgrading.
5. After upgrading firmware, release the short on the Main PCB.
After removing the soldering
LCD
To Next Page
Loading...
