Samsung DM82E-BM

23
Reverse Side
―
The colour and shape of parts may differ from what is shown. Specifications are
subject to change without notice to improve quality.
―
Models DM82E-BR and DM82E-BM are only supported.
RGB / DVI /
HDMI / AV /
COMPONENT
AUDIO IN
AUDIO
OUT
RS232C
OUT
RS232C IN
SD CARD
DVI /
MAGICINFO IN
HDMI IN 1
HDMI IN 2
DP IN
IR /
AMBIENT
SENSOR IN
TRAY IN RJ45RGB IN
COMPONENT IN
IR
OUT
TOUCH OUT
USB
(5V 1A)
(5V 1A) /
TOUCH IN
USB
Port Description
RS232C IN
Connects to MDC using an RS232C adapter.
RS232C OUT
IR / AMBIENT SENSOR IN
Supplies power to the external sensor board or receives the light sensor signal.
RGB / DVI / HDMI / AV /
COMPONENT AUDIO IN
Receives sound from a PC via an audio cable.
AUDIO OUT
Connects to the audio of a source device.
SD CARD
Connect to an SD memory card.
USB (5V 1A)
Connect to a USB memory device.
―
The USB ports on the product accept a maximum constant current of 1A. If the
maximum value is exceeded, USB ports may not work.
USB (5V 1A) / TOUCH IN USB (5V 1A): Connects to a USB device. Make sure the Touch is not in use.
TOUCH IN: This must be connected to the cable if the Touch is in use.
DVI / MAGICINFO IN DVI: Connects to a source device using a DVI cable or HDMI-DVI cable.
MAGICINFO IN: Use the (dedicated) DP-DVI cable when connecting a network box (sold
separately).
DP IN
Connects to a PC using a DP cable.
HDMI IN1 / HDMI IN 2
Connects to a source device using an HDMI cable.
TRAY IN Connects to the Tray, found on the front of the product, using the OCM cable.
RGB IN
Connects to a source device using a D-SUB cable.
TOUCH OUT Connects the Touch to a PC.
AV IN / COMPONENT IN
Connects to a source device using the AV/Component adapter.
IR OUT
Receives the remote control signal via the external sensor board and outputs the signal via
LOOP OUT.
RJ45
Connects to MDC using a LAN cable.