9
ASSEMBLING YOUR KEYSET
• Place the keyset face down on a flat surface.
• Insert notched ends of the support bracket into the channels located in the
upper section of the bottom panel. Push towards the top of the keyset to lock
in.
• Plug the handset cord into the jack marked with the symbol.
• Route the handset cord out the RIGHT side of the keyset as you look at it face
down.
• Plug the four-conductor line cord, from the wall, into the jack with the
symbol on the bottom of the keyset.
ds_phones.qxp 5/27/2009 3:55 PM Page 15
To Next Page
