Installation
English32
Installation
Door reversal
Type 1
1. Put a soft rug on the oor to rest the
door on after you have removed it.
This will prevent the door from being
scratched.
2. Unplug the power cord.
3. Remove two door hinge screws.
4. Lift the door and remove it.
NOTE
There is a screw on the back side of the
hinge that will support the door as you
unscrew the hinge screws.
5. Remove the two screws that are above
and below the cut-out in the frame
front.
6. Remove the two screws above and
below the lever holder on the opposite
side of the door opening.
Untitled-10 32 2020-07-14 3:22:16
To Next Page
Loading...
