Samsung DW80H9950US/AA

To Next Page

This information is published for informational purposes only and intended for use only by personnel qualified for the specific tasks

depicted. Qualified personnel are those who, based on their training and experience, are capable of identifying risks and avoiding

potential hazards when handling or servicing a product. Only qualified personnel should repair products powered by electricity. Any

attempt to handle, service or repair the product or products by anyone other than qualified personnel could result in serious injury or

death. You agree that your use of and reliance on this information is at your sole risk. This information is subject to change or update

without notice. There are no warranties, either expressed or implied, regarding the accuracy or completeness of this information.

SUBJECT: LE error code or water leak from

under the door

Background: Some instances of an LE error code or water leak from under the door are caused

by installation errors. Check the installation of the 90 degree elbow on the water valve. Make sure

that white Teflon tape has been used and that the elbow is tightened correctly. Also ensure that the

water supply line is properly tightened. In addition, check the condition of the drain hose in the

back of the dishwasher.

Make sure that the clamp

is correctly installed.

Ensure the hose is not

crimped.

SERVICE BULLETIN

Product:

Dishwasher

Bulletin Date: 8/18/2014

Bulletin Number: ASC20140818001

Models:

DW80H9930US/AA,

DW80H9950US/AA,

DW80H9970US/AA

ELECTRONICS

If the elbow is not connected

correctly, water can flow into the

shutter under the dishwasher and

cause an LE error code.

Make sure that the water line is

properly connected.

Water mark and LE

error caused by

installation defect.

Water mark and LE

error caused by

installation defect.

Need help?

Do you have a question about the Samsung DW80H9950US/AA and is the answer not in the manual?

Summary

LE Error Code or Water Leak from Under the Dishwasher Door

Background: Causes of LE Error and Water Leaks

Explains that LE error codes or water leaks are often caused by installation errors related to the 90-degree elbow on the water valve.

Visual Diagnosis of Installation Defects

Illustrates common installation issues causing water leaks and LE error codes, focusing on water supply line and drain hose connections.

Solution: Troubleshooting and Repair Procedures

Correcting Water Inlet Connections

Provides steps to install Teflon tape, tighten the elbow fitting to the 4 o'clock position, and connect the water supply line correctly.

Securing Drain Hose and Replacing if Damaged

Instructs to ensure the drain hose clamp is properly positioned and to replace the hose if damaged, referencing part DD67-00115A.