142
the interference by one or more of the following
measures:
• Reorient / relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult your dealer or an experienced radio/TV
technician for help.
Specific Absorption Rates (SAR)
The SAR is a value that corresponds to the relative
amount of RF energy absorbed in the head of a
user of a wireless handset.
The SAR value of a phone is the result of an
extensive testing, measuring and calculation
process. It does not represent how much RF the
phone emits. All phone models are tested at their
highest value in strict laboratory settings. But when
in operation, the SAR of a phone can be
substantially less than the level reported to the
FCC. This is because of a variety of factors
including its proximity to a base station antenna,
phone design and other factors. What is important
to remember is that each phone meets strict federal
guidelines. Variations in SARs do not represent a
variation in safety.
All phones must meet the federal standard, which
incorporates a substantial margin of safety. SAR
values at or below the federal standard of 1.6 W/kg
are considered safe for use by the public.
Maximum measured SAR values for the A667T are:
• GSM 850: Head 0.41 W/kg, Body 1.04 W/kg
• GSM 1900: Head 0.47 W/kg, Body 0.63 W/kg
• UMTS V: Head 0.39 W/kg, Body 0.50 W/kg
• UMTS II: Head 1.00 W/kg, Body 0.76W/kg
To Next Page
