EasyManua.ls Logo

Samsung F1015JGB/YLP - Fuzzy Washing Function; Bubble Detecting Function

Samsung F1015JGB/YLP
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
5. Main function
10) Fuzzy washing function ( weight-sensing)
After finishing initial water supply, when the fall of the water level needs supplementary water supply,
Sensing function perceives the weight with the supplementary water supply numbers and starts to work.
Under the course of Cotton, or Coloureds, if the supplementary water supply numbers become 3 - 4 times the
function is going at default condition ( high water level ), if 1-2 below that is going at middle level, if 0 below
low water level, heating hours and rinse hours depend on the above data.
ECO PRE mode is selected, the process going on at default condition.
After sensing weight, above hours is decreased from above default hours
11) Bubble -detecting function
At the each condition of washing&dehydrating , rinse&dehydrating , hydrating, bubble -detecting function works,
this function works 5times normally, if the function detects bubbles at 6 times , the bubble-detecting function
stops and go on to the next process.
The bubble-detecting function during washing & dehydrating to rinse & dehydrating
after 2 times instant dehydrating and before main dehydrating, if the water level is under 25.45KHZ, Bubble
Detecting function thinks there are bubbles and add the bubbles-removing rinse, needing hours are above
hours and 8 min 40 sec.
The bubble-detecting function during single hydrating process
after 2 times instant dehydrating and before main dehydrating , if the water level is 25.45KHZ below or
during main dehydrating, water level data is 23.80KHZ below Bubble-detecting function thinks there are
bubbles and add the bubbles-removing rinse 1 times, needing hours are above hours and 5 min 55 sec.
Washing hours
Rinse water level
Cotton Coloureds
High Default Default Default
Middle Default-12 min Default-7min 23.30KHZ
Low Default-25 min Default-15min 23.70KHZ
draining &reverse
1min
unbalance
detecting range
20 sec
laundry scattering
bubble detection
(default water level 25.45KHZ below)
500rpm
Bubble-detecting function operating process
600rpm

Related product manuals