To Next PageTo Next Page
Need help?Do you have a question about the Samsung F1015JGB/YLP and is the answer not in the manual?
Checks PCB connector, voltage, plug, noise filter, and fuse for power issues.
Checks knob, start button, water valve connection, and pressure switch.
Checks pressure switch, hose, and water level switch for startup problems.
Checks belt, motor winding, and motor protector for rotation issues.
Checks drain hose, pump winding, and drain filter for drainage issues.
Checks outlet grounding, current leaks, and breaker capacity.
Checks heater terminal connection and heater normal operation.
Guides checking voltages at different points in the power source circuit.
Checks the 5V measurement result for the reset circuit.
Checks curve output, Micom number, and oscillator for interrupt issues.
Verifies the 8MHz frequency of the Micom oscillator.
Confirms DC12V for the buzzer and checks associated resistors.
Checks DC5V output for driving parts and specific ICs like 65003.
Checks BD1, TRIAC1, and RELAY2 for motor driving circuits.
Checks the rectangular curve output for the tacho signal.
Guides on adjusting machine legs for proper leveling and stability.
Error occurs when water level doesn't change or supply is slow, cleared by power cycle.
Error when water level is too low during UNB-detecting cycle, cleared by power cycle.
Error for abnormal water level; drains water and displays E3, cleared by power cycle.
Occurs with uneven laundry load, cleared by power cycle after fixing.
Detects rapid temperature changes or overheating; cleared by power cycle.
Triggered by abnormal pressure switch signals, causing drain pump operation.
Error for high temperatures in Delicate/Wool cycles, cleared by power cycle.
Occurs when water drains naturally after the program starts; cleared by power cycle.
General